This hitch is being used on a Jonh Deere 420. The hitch is very nicely made and made of a good thick steel. The only problem I had, was that one of the predrilled holes on the bottom square pads mounted to the under part of the axle was off by about 1/2â€. After I redrilled the hole it all line up.
When I received the hitch, I noticed that the mounting plates were on the wrong arms, according to your picture. Otherwise everything was okay. I'll soon use it
Package arrived on time. There were no instructions. I took part of the old lift off before I realized I needed it to mount the 3-point setup. Should have locking nuts on every bolt not just chain bolts. Bolts have already come lose. The small bolts that connect on the top lift arms needed longer bolts. Gap too large between the lift arm and the axle mount plate, and top link. Added 5 spacer washers to take up most of the gap on each side. It works well though once installed.